2017 Kia Optima POWER TRAIN,ENGINE

Vehicle experiences sudden and dangerous loss of power while driving, including hesitation during acceleration, consistent with connecting-rod bearing failure risk known in this model’s GDI engine. Dealer estimate found timing and oil-flow component failures connected to internal engine damage. Vehicle is unsafe to drive and stalls/lacks power unexpectedly, creating a high risk of crash.”

Engine is failing and using over 3 quarts of oil every 700-100 miles. Spark Plugs have become oil fouled and replaced all 4 spark plugs June 11th, 2024 and replaced all 4 spark plugs again January 12th, 2025. Today July 7th, 2025 Check Engine light came back on with Engine Misfire code P0303 Cylinder 3 Misfire, changing spark plugs again today. My safety is put at risk because oil consumption is a know issue with Kia GDI Engines. At any moment my car can run out of oil if it is not check every other week causing my engine to completely fail or a spark plug become Oil fouled and a spark plug needing to be replaced. In July of 2024 when this happened I was on the highway going 70 mph and my car just completed shut down. I could have been seriously injured had I not been able to pull over and only been 5 miles away from my home. I called Kia today to start an Oil Consumption test, stated I am the 2nd owner and while this is a known issue I will pay for and Upper Engine Clean which is only a band aid. This problem has been confirmed with Kia that the GDI Engines are consuming oil. I have also replaced all Engine Coolant, Coolant Temperature Senor, Thermostat as well as the PCV Valve.

Vehicle had oil change & filter service done on April 27, 2023 for the purpose of hoping the service would rectify an Oil Pressure Sensor Light illuminated on the dashboard. It did not. Sensor was subsequently replaced by the dealer. Vehicle taken into the dealership today (September 2, 2023) for Pennsylvania State Inspection and Emissions, along with another oil change service. Dealer technician in the course of performing the oil change, noticed after he put the new oil plug washer and bolt back in place, a minute crack in the oil pan, itself. He took a picture of it, that I will include with this complaint. Unfortunately, the definition of the photo leaves a bit to be desired. The dealer service writer suggested that too much force (pneumatic socket driver) was employed when tightening the oil pan bolt. I stopped at the location where the April 27, 2023 was done. The General Manager assured me they use a power torgue ratchet and not a pneumatic socket driver. He went under the car and detected a minute leak and said he would forward his report to their Quality Control Department. He asked me if I could bring the car back on Tuesday or Wednesday, September 5th or 6th for a re-inspection. I said I would do that. He did mention there is a possible Class Action Suit that might be filed over Kia/Hyundai Oil Pans and Bolts. It cites the use of poor materials used in the pan construction. Reports range from leaks to the oil bolt plug falling out due to expansion/contraction under duress. Don't know where or when any Class Action will manifest itself, but this oil change facility needs to step up and replace the oil pan, since they were the last ones to do a change before today.

Engine oil consumption, I have owned this car since new and almost every other week I need to add oil. My car has 85k miles on it , and has been service by dealer since new, just 2 months ago Pomona kia said my oil pan gasket had a small leak and replaced the gasket, today 3500 miles after the gasket replacement my car needed 3 quarts of oil. I'm not a mechanic but I know my car should not go trough so much oil. Someone please help.

Large Oil consumption (1qt a week). No warning lights, experiencing loss of power, hesitation on acceleration, oil covering the motor with no signs of leaks underneath the car on the streets. Oil puddling up on the top of the valve cover near the plugs but unable to locate the source. Gaskets and hoses checked and all are in good condition. 125,000 miles.

I was driving on the highway when my check engine light came on flashing the car jersey almost to a stop and I had to pull over. I cut the car off and sat then turned it back on. The check engine light was still flashing and I put my flashers on and was unable to go over 60 mph. I drove slowly to an autozone and a code was pulled p1326. I looked it up and it undeliverable due to the knock sensor issue.

A LOUD KNOCKING NOISE IN THE CAR 61K MILES..BASICALLY THE DEALSHIP IS SAYING THE CAR NEEDS A NEW ENGINE