2018 Ford Fusion ENGINE AND ENGINE COOLING,ENGINE

The contact owns a 2018 Ford Fusion. The contact stated that the check engine warning light was displayed on the instrument panel. The vehicle was taken to an independent mechanic, where a code reader determined that there was a misfire in cylinders #1 and #3. The vehicle was taken to a dealer, where the engine misfires were confirmed, and the engine's long block needed to be replaced. Upon investigation, the contact discovered Technical Service Bulletin: 22-2229; however, the vehicle was not covered under the TSB. The vehicle was not repaired. The manufacturer was notified of the failure but offered no assistance. The contact was referred to the NHTSA Hotline to file a complaint. The failure mileage was 88,300.

The contact owns a 2018 Ford Fusion. The contact stated while driving at an undisclosed speed, the engine overheated and the check engine warning light illuminated. In addition, the contact noticed white smoke coming from the exhaust, and the engine was running abnormally rough. The vehicle was taken to the dealer, where it was diagnosed with coolant intrusion in cylinder #1, causing engine failure. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure. The contact was advised to contact the NHTSA Hotline to report the failure. The failure mileage was approximately 115,000.

The contact owns a 2018 Ford Fusion. The contact stated that while her son was driving 70 MPH, the check engine warning light illuminated. The vehicle began to run rough, and the driver veered to the side of the road. The vehicle was towed to the local Nissan dealer, where it was diagnosed that there was no coolant in cylinder #2, and the head gasket was blown. The driver was referred to the local Ford dealer. The driver called the local dealer and was informed that there was no recall or Customer Satisfaction Program coverage for the repair. The vehicle was shipped back to the contact's residence. The vehicle was towed to the local dealer where it was diagnosed that an engine replacement was needed. The vehicle was not repaired. The contact stated that the manufacturer had been contacted and the contact was referred to the NHTSA Hotline. The failure mileage was approximately 94,444.

The contact owns a 2018 Ford Fusion. The contact stated that while driving at an undisclosed speed, the vehicle briefly hesitated and jerked, prompting the contact to pull over to the shoulder of the roadway. After pulling over, the contact observed that the vehicle was idling rough and turned off the vehicle. Upon attempting to restart the vehicle, the vehicle initially failed to start and required a jump start. The check engine warning light was illuminated. The vehicle was taken to the dealer, who observed coolant intrusion into cylinder #3, resulting in engine damage. The contact was informed that the long block needed to be replaced. The vehicle was not repaired. After investigating the failure, the contact related the failure to Customer Satisfaction Program: 21N12. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the NHTSA Hotline for assistance. The failure mileage was 102,000.

See attached document for complaint

The contact owns a 2018 Ford Fusion. The contact stated while driving at an undisclosed speed, there was an engine misfire, and the low coolant level warning light illuminated. The vehicle was taken to the dealer where it was diagnosed with coolant intrusion into cylinder #2 and engine failure. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure but provided no assistance. The contact was informed that the repair was not covered under Customer Satisfaction Program: 21N12. The contact was advised to contact the NHTSA Hotline to report the failure. The failure mileage was approximately 56,000.

The contact owns a 2018 Ford Fusion. The contact stated while driving at an undisclosed speed, the message "Coolant System Temperature Above" was displayed, and the vehicle stalled. An unknown dealer was notified of the failure. The vehicle was taken to an independent mechanic, where it was diagnosed that the engine had failed and needed to be repaired. The vehicle was not repaired. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 90,000.

The contact owns a 2018 Ford Fusion. The contact stated that while driving at an undisclosed speed, the temperature gauge indicated that the engine was overheating, and the vehicle briefly shuddered. The check engine warning light was illuminated. The vehicle was taken to an independent mechanic, who diagnosed failures with the head gasket and turbo charger. The vehicle was not repaired. The manufacturer was notified of the failure but referred the contact to the NHTSA Hotline for assistance. The failure mileage was 75,000.

The contact owns a 2018 Ford Fusion. The contact stated that the check engine warning light was illuminated. The contact took the vehicle to a certified mechanic who after 3 days diagnosed and determined there was coolant intrusion into cylinder #2. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The contact spoke with the dealer and was informed that the failure was a known issue; however, the VIN was not under recall. The manufacturer was not made aware of the failure. The approximate failure mileage was 127,000.

The contact owns a 2018 Ford Fusion. The contact stated that while driving uphill at an undisclosed speed, the check engine warning light remained illuminated with the engine temperature gauge showing that the engine was overheating. The vehicle was taken to the local mechanic who diagnosed that the engine was faulty and needed to be replaced. The vehicle was not yet repaired. The manufacturer and local dealer were notified of the failure, but no assistance was offered. The failure mileage was 124,000.

The contact owns a 2018 Ford Fusion. The contact stated that while driving at an undisclosed speed, the vehicle inadvertently lost motive power. The contact was able to pull over to the shoulder of the roadway, where the vehicle was able to be restarted. The engine overheating warning light was illuminated. The vehicle was towed to the dealer, who determined coolant intrusion had caused damages to the engine. The vehicle was not repaired. The manufacturer was notified of the failure but referred the contact to the NHTSA Hotline for assistance. The failure mileage was 96,000.

The contact owns a 2018 Ford Fusion. The contact stated that while operating the vehicle, there was a sound of liquid present inside the dashboard. The vehicle was taken to the local dealer who diagnosed that engine coolant was present inside the engine cylinders and the engine short block needed to be placed. The engine short block was replaced but later the vehicle began to drive sluggishly and would not properly accelerate. The vehicle was taken to a second dealer who diagnosed that the engine was faulty and needed to be replaced. The vehicle was not yet repaired. The manufacturer was notified of the failure. The failure mileage was 110,000.

The contact owns a 2018 Ford Fusion. The contact stated while driving at various speeds, the vehicle failed to accelerate while depressing of the accelerator pedal, with the check engine warning light flashing on the instrument panel. The contact had taken the vehicle to a dealer where he was informed that coolant was leaking into the engine cylinders. The manufacturer was notified of the failure and the contact was given a case number. The manufacturer later was informed that the vehicle would not be covered under warranty or recall. The vehicle was not repaired. The failure mileage was approximately 78,000. The consumer stated the vehicle had a coolant leak in the engine which caused corrosion and other damage to the engine.

The contact owns a 2018 Ford Fusion. The contact stated that while operating the vehicle, the check engine warning light remained illuminated with a message stating "Engine Coolant Over Temperature" displayed. Additionally, the engine sputtered while the vehicle was being started and there was gray smoke coming from the exhaust pipes. The contact stated that the vehicle would not properly accelerate while depressing the accelerator pedal. The vehicle was taken to the local dealer who diagnosed the vehicle and determined that coolant was leaking into cylinder #1, causing damage to the engine long block. The contact was informed that the engine needed to be replaced. The vehicle was not yet repaired. The manufacturer was notified of the failure but no assistance was offered. The failure mileage was 112,000.